Sanyo ECR-238 - Page 10

7. SELF DIAGNOSTIC
Key Sequence
<P mode>
(77)--ST ALL--(Machine number)--[#/NS]
(AUTO) (1) Display Check
| All figures will be displayed. Make sure the
all digits and segments are displayed.
(AUTO) (2) RAM Check
| The RAM check result will be printed out.
(See bellows receipt sample)
(AUTO) (8) Printing Check
| All internal characters will be printed out.
(See bellows receipt sample)
[ST ALL] — (4) Mode lock Check.
Turn the mode lock position from P to Z,
M, X, R and OFF.
[ST fe — (5) Key-code Check.
Press any key except "#/NS", and "1" key.
Display shows the key-code that has been
programmed.
(See "Keyboard Programming")
[#/NS] (6) Drawer open Check and terminate this
routine.
**+ RAM check result
(77: O.K.)
OONOOHWPD
® ASLSLS<#RBON! +
AQLeSLc#IOR!1+0
* 7
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
x
8. ERROR CODE & MESSAGE
The machine will inform you with the following error
message on the display.
ERROR CODE ERROR CAUSE
EO * Is the figure entered over the capacity ?
Input Capacity Function and Tendering key Max.8 digits
Over Department key Max.7 digits
Multiplication
* Quantity Max.5 digits
* Unit price Max.7 digits
* Product Max.7 digits
Split pricing
* Package quantity Max.2 digits
* Purchased quanti Max.2 digits
* Is the amount entered over the entry limit
E2
Entry limit over programmed ?
Operation error | * Please read this instruction manual again.
E4 *Did you enter an amount before
Compulsory error | depression the key ?
* Did you depress [ST ALL] key before the
tendering key ?
* Did you close the drawer when operating
* Is the amount entered over the display ?
* Customer total Max.8 digits
* Discount total > Customer total
* Previous item void > Customer total
* ls the key allow to operate in the R mode ?
?
E5
Amount overflow
or Negative error
E6
Prohibited *Did you enter the correct Report ID
operation by mode ?
programming *Did you enter the correct machine
number ?
* Did you program the prohibit status ?
* Is the times over the programmed limit ?
Delayed receipt
E7 * Is the mode lock placed properly ?
Mode error * Did you complete the previous operation ?
NOTE : if only certain key operation results in an
error, it may be related to your programming.
Please confirm the programming of the
associated key.