Sanyo ECR-238 - Page 11

OTHER PROBLEMS
Please check the following items before calling for
service.
Check points
The display does | * Is power distributed to the outlet ?
not show up in * Is the AC plug connected firmly to the
other than OFF outlet ?
position.
The drawer does | * Did you unlock the drawer ?
not open.
No Receipt is * Is the Receipt paper installed properly ?
issued. * Is the Receipt OFF/ON key in the OFF
position ?
* Is there any paper jam ?
indistinct * Is the ink ribbon wom out ?
is indistinct * Is the ink of Logo Stamp wom out ?
No Confirmation | * Did not you program "tone generate" to
tone is generated | be OFF ?
when depressing
the numeric key.
Interlock due to
programming
* Interlock may be occur by improper
programming. In this case, the machine
may recover as per the following
operation.
(1) Remove the AC plug from the outlet.
(2) Tum the Mode lock to the P position.
(3) Connect the AC plug to the outlet
again while depressing the Paper
Feed keys both about in one second.
(4) Confirm the associated
programming.
(5) Reprogram the associated items
correctly.
You can use the different key size such as a single-
size, double-sized or quadruple-size at any position
on your keyboard except for paper feed key, clear key
and numeric keys. If you need further information for
these optional keys, please ask your local dealer.
Optional key Installation
(1) Single-sized key
1. Put the coil spring on the housing.
2. Install the key top, keysheet and key cap.
(2) Double-sized key
1. Put the coil spring and key top guide on the
housing.
2. Install the key top, keysheet and key cap.
(3) Quadruple-sized key
Install the same procedures (2).
(1) Single-sized key
key cap — >
keysheet — <>
key top —
coil spring —— S
!
|
D
(2) Double-sized key
key cap—
keysheet —— a
key top —
springA——— |
coil spring =
key top guide j—
'
ue
(3) Quadruple-sized key
<> — key cap
4 S —— keysheet
— key top
u U
| sf! spring-A
= | 1 —— coil spring
j =| §— key top guide
Precaution for change the keys
When you change the key size, make sure the active
spring-A is in correct position.
—~9-