10
OPERATING INSTRUCTIONS
SIGNALS DURING OVEN SETTINGS
ONE SIGNIAL: Oven accepts the entry.
TWO SIGNALS: Oven does not accept the entry,
check and try again.
SETTING THE CLOCK
Step 1: Press CLOCK button.
2:Use the number pads to enter the correct
time. You must press at least three numbers to
set the clock (one for the hour and two for the
minutes).
3:Press CLOCK button again to confirm.
NOTE:
• This is a 12-hour clock. When the oven is
plugged in or when power resumes after a
power interruption, the display will show
ENTER CLOCK TIME. If you prefer not to
have the clock displayed press RESET.
• You can check the clock time while cooking is
in progress by touching the CLOCK pad.
SETTING THE KITCHEN TIMER
Step 1: Press KITCHEN TIMER button.
2: Enter the amount of time by pressing the
number pads. Digit time is in minutes and
seconds and set from left to right. Set one digit
(a 5 for 5 seconds) or up to four digits (2405
for 24 minutes, 5 seconds).
3: Press START button.
NOTE:
• Time countdown can be seen in display or 3
seconds before clock or cooking time is
returned to display.
• Press KITCHEN TIMER and then press
RESET to cancel TIMER during timing
process.
SETTING A COOKING PROGRAMME
A. One-Stage cooking.
1. Use the number pads to set a cooking time. You
can set a cooking time from one second to 99
seconds.
2. If you want to set a power level other than
100% power, press POWER, then use the
number pads to enter the power level from 1 to
9.
3. Press START or start cooking.
USE SINGLE DIGITS TO SET A COOKING
POWER LEVEL
Number button % of Power
9 90%
8 80%
7 70%
6 60%
5 50%
4 40%
3 30%
2 20%
1 10%
B. Two-stage Cooking.
Some recipes require two stages of cooking at
different temperatures.
1. SET STAGE 1:
Follow steps 1 & 2 in “One-stage Cooking”.
DO NOT TOUCH START BUTTON.
2. SET STAGE 2:
Press COOK TIME button then enter the
proper cooking time and (lower) power level.
(Most 2-stage recipes require a lower power
for the second stage).
3. Press START button.
NOTE:
• After stage 1 time has elapsed, one signal
sounds, signaling the beginning of stage 2.
After total time has elapsed. 4 signals sound
and END appears in display. Press RESET or
open oven door to clear END before starting
another cooking function.
To Next Page
Loading...
