Sanyo FWSB405FS User Manual

–
11
–
EN
Adjust the volume
Use your Soundbar
Note(s):
• The volume might be infl uenced by MP3 or Bluethooth player. If the volume is too low, adjust the volume on the connected device.
• If the volume level is set above 15 when the Soundbar is turned Off, the volume will automatically be reset to 15 when the
Soundbar is turned back On.
1) To increase or decrease volume, press VOL +/- on remote control.
• To mute sound, press
on remote control.
– When the mute on, the POWER indicator on the front panel of main unit blinks in red.
– When the mute off, the POWER indicator stop blink and light off.
• To restore the sound, press
again or press VOL +/-.
Volume LED display
Behavior
0
〜
5
Lights up for 3 seconds (default: level 10)
6
〜
11
12
〜
17
18
〜
23
24
〜
29
• When pressing [VOL+/-], the indicator will show the current volume. Pressing [VOL+/-] while the current volume is shown will
increase/decrease the volume.
• Pressing and holding [VOL+] or [VOL-] will increase or decrease the volume and the indicator will blink. When the volume has
reached the maximum or minimum, the indicator will stop blinking.
Adjusting the volume (default: level 10)

Sanyo FWSB405FS Specifications

General

Brand	Sanyo
Model	FWSB405FS
Category	Speaker System
Language	English