Sanyo FWSB405FS - Bluetooth Operation; Bluetooth Connection and Playback

–
13
–
EN
Play audio through bluetooth
Factory default
Note(s):
• If reconnecting the Bluetooth device to the Soundbar fails, delete the registered profi le of this Soundbar from the Bluetooth device,
then perform pairing again.
This unit can store up to 4 device profi les.
• The music streaming may be interrupted by obstacles between the device and Soundbar, such as wall, metallic casing that covers
the device, or other devices nearby that operate in the same frequency.
• If you want to connect your Soundbar with another Bluetooth device, press to disconnect the currently connection.
• Depending on your Bluetooth device, different behaviors may appear. See your Bluetooth device’s user manual for details.
• The operational range between the SoundBar and a Bluetooth device is approximately 30 feet (10m).
1) Press
on the remote control to switch the Soundbar to Bluetooth mode.
2) Turn On the Bluetooth compatible device.
3) On the Bluetooth device, switch on Bluetooth, search for and select SANYO_FWSB405F (see the user manual of the Bluetooth
device on how to enable Bluetooth).
• If a Passcode is requested, enter “0000”.
• If the Soundbar name does not appear on the Bluetooth compatible device, press
on the remote control.
4) Play music on the connected Bluetooth compatible device.
5) To exit Bluetooth mode, press one of the other audio input source buttons on the remote control.
1) To reset the Soundbar to the factory default settings, press
5 times within 3 seconds. After completion of reset, the
Soundbar will be shut down and go into Standby mode.
PAIR indicator behavior
The arrow indicates the passage of time.
The current status of Bluetooth and the procedures to
complete Bluetooth connection for Bluetooth playback.
1
Blinks twice
→
Light off
→
Repeats
Waiting for a new Bluetooth Device to connect (Status: Pairing).
On the Bluetooth Device to connect, select the Soundbar’s name
(*1)
, then connect.
2
Remains lit
A Bluetooth Device is connected.
Music can be played from the connected Bluetooth Device
(*2)
.
3
Blinks slowly
No Bluetooth Device is connected. To reconnect with the last
connected Bluetooth Device, press
(*2)
.
4
Blinks rapidly
Trying to connect with the last connected Bluetooth Device.
Enable Bluetooth on the last connected Bluetooth Device and
wait a moment
(*2)
.
5
Remains unlit
Either another audio input is selected or the Soundbar is in
Standby.
If the POWER indicator is On (Status: Standby), press to
turn On the Soundbar. When the POWER indicator is Off and any
orange indicator is On, press
. The (Bluetooth) indicator will
start blinking or light up. Follow 1-4 in this chart.
*1
This Soundbar’s name is “SANYO_FWSB405F”. If this Soundbar has already been registered to a Bluetooth Device and the
connection fails, delete it (or deactivate it), then press and select this Sound bar’s name to connect.
*2
To play music from a different Bluetooth Device, press , then select this Soundbar’s name on the Bluetooth Device to
connect
(*1)
.