-8-
BASX
.......................................................................3
The low-frequency sound is enhanced at all volume levels.
To cancel the effect, press the SOUND button
for more than 1.5 seconds and BASS is displayed.
Press the button again to restore BASX function and BASS is disappeared.
RADIO SELECTION BUTTON (BAND)
......................... 4
Press the BAND button
to switch from CD player, or CD changer mode to radio.
Each time the button is pressed, the function changes as shown below.
CD PLAYER OR CD CHANGER SELECTION BUTTON
(CD/POWER/CD-CH)
................................................. 1
Press the CD/POWER/CD-CH button
to switch from radio mode to CD player or CD changer* mode.
* If a CD changer is connected.
Pressing the button will change the mode as follows:
When a CD is loaded in the CD player and a CD changer is not connected;
When a CD is not loaded in the CD player and a CD changer is connected;
When a CD is loaded in the CD player and a CD changer is connected;
CLOCK BUTTON (DISP)
............................................ 5
Press the DISP button
to switch between the clock and audio display. When an audio function is
performed while the time display is selected, the audio display will appear for 5 seconds, then the display
will return to the time mode.
BEEP TONES
........................................................... 1, 6
You can set the radio without beep tones which will sound when a button is pressed. To set the function,
follow the procedures below.
Turn off the power by pressing the POWER button
for more than 1.5 seconds.
With ACC on, press the POWER button
and > button
simultaneously until “b-oF” is displayed.
To set the beep tones on again, repeat steps 1 and 2, and then “b-on” is displayed.
1
2
3
Radio CD player
CD changer
1
2
3
FMI FMII MW
Radio CD player
Radio CD changer
FXD‑885GDE.fm8ページ２００３年１１月１１日 火曜日 午前１１時４０分
To Next Page
Loading...