To Next PageTo Next PageWhy is my Sanyo FXD-780GD not turning on?
If your Sanyo Car Receiver isn't powering on, there are a couple of things to check: * First, make sure your vehicle ignition is switched to the “ON” or “ACC” position. * Second, examine the fuse. If it's blown, replace it with another 10A fuse.
What to do if my Sanyo Car Receiver CD player skips?
If the CD player in your Sanyo Car Receiver is skipping, consider the following: 1. If the road surface is rough, wait for it to improve before playing a disc. 2. Ensure the unit is securely mounted, using the rear strap if your vehicle doesn't support the unit's rear. 3. Try another disc, as the first may be defective. 4. If the disc is dirty, clean it.
Why does my Sanyo FXD-780GD Car Receiver have no radio reception?
If you're experiencing no radio reception with your Sanyo Car Receiver, ensure the antenna cable is firmly inserted into the antenna jack on the unit.
What to do if my Sanyo FXD-780GD Car Receiver unit does not work properly (Eject, Load, Play)?
If your Sanyo Car Receiver isn't working properly (Eject, Load, Play), the microcomputer may have been affected by electrical noise. Eject the disc, then insert it again.
What to do if Sanyo Car Receiver radio does not stop on any stations when automatic tuning is used?
If the radio in your Sanyo Car Receiver doesn't stop on stations when using automatic tuning, the signals might be weak. Try selecting a station using manual tuning.
General| Brand | Sanyo |
|---|---|
| Model | FXD-780GD |
| Category | Car Receiver |
| Channels | 4 |
| Display Type | LCD |
| CD Player | Yes |
| MP3 Playback | Yes |
| WMA Playback | Yes |
| USB Port | Yes |
| Auxiliary Input | Yes |
| Bluetooth | No |
| Detachable Faceplate | Yes |
| Tuner Bands | AM/FM |
| Playback | CD |
How to turn the unit on and start operation.
Procedure to power down the unit and display clock.
Instructions for adjusting audio volume using the dial.
Muting the audio output and restoring volume.
How to set the 24-hour clock display.
Boosting bass and treble at low volumes for better audio.
Selecting radio signal strength for tuning.
Adjusting bass enhancement levels (LOW to Very high).
Storing custom sound stage balance and fader settings.
Recalling stored sound stage presets.
Changing display modes between radio and CD information.
Displaying the clock when the ignition is off.
Switching between FM1, FM2, FM3, AM1, and AM2 bands.
Automatic and manual tuning for receiving stations.
Programming favorite stations into memory.
Scanning stations for 10 seconds each.
Scanning stored preset stations.
Instructions for inserting and removing CDs.
Changing from radio mode to CD playback mode.
Navigating to the next or previous track.
List and overview of included installation parts.
Detailed steps for installing with a mounting strap.
Detailed steps for installing using a bushing.
Diagrams and explanations for connecting wires.
