18
Notes
• When using a two-speaker installation, the Green, Green/Black, Violet, Vio-
let/Black wires, which are used for a four-speaker installation, are not used.
The ends of these wires must be covered with electrical tape to prevent them
from shorting to the unit or the vehicle chassis.
• When using a two-speaker installation, set the FADER control to the center
position.
REPLACING THE FUSE
When fuse replacement is necessary remove the blown fuse
by using pliers. Then install the new 10 amp. fuse.
LINE OUT CONNECTIONS
• The unit has a line out terminals. You can use a separate rear channel amplifier to upgrade your system.
External Amplifier
Rear Speaker
White (Left)
Red (Right)
RCA Line-out Jacks
RCA Line- out Jacks (For Rear Speakers)
• Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA
line output jacks to the line input terminals of the external amplifier.
FXD-780GD_Ebody 03/04/2002, 04:45 pm18
To Next Page
Loading...