Sanyo FXD-780GD - ADJUSTING THE SOUND CHARACTERISTICS; LOUDNESS EFFECT; LOCAL;DISTANT (LO;DX) SELECTION; ENHANCING THE BASS SOUND (BAS-X)

6
ADJUSTING THE SOUND
CHARACTERISTICS ..............................................4,2
1. Each time you press the AUDIO button 4 until the desired mode is displayed.
2. Rotate the VOL dial 2 to adjust the selected item. Make the adjustment within 5 seconds after selecting.
After 5 seconds, the display window will revert to display priority.
• El LE(medidor de nivel) puede seleccionarse entre Hi (alta sensibilidad), Lo (sensibilidad normal), y OFF
(sin indicación).
• MUTE LEVEL controla el nivel de volumen aplicado cuando se silencia el sonido. Podrá ajustar el nivel
en el que se reduce el volumen desde el nivel de volumen anterior.
Adjustment Range
BASS BASS –5 BASS +5
TREBLE TREB –5 TREB +5
BAL L9 (Full left) R9 (Full right)
FAD F9 (Full front) R9 (Full rear)
LE(Level Meter) Hi Lo OFF
MUTE LEVEL – 0 –20 –80
LOUDNESS EFFECT ......................................................................... 5
When listening to music at low volume levels, this feature will boost the extremes of the bass and treble
ranges to compensate for the negative characteristics of human hearing.
Press the LOUD LO/DX button 5. The “LOUD” indicator appears in the display window.
Pressing the button again will cancel this feature.
LOCAL/DISTANT (LO/DX) SELECTION ........................................... 5
This feature is used to select the strength of the signals at which the radio will stop during Automatic
Tuning. Press the LOUD LO/DX button 5 for more than 2 seconds to select the Local (LO) setting and only
the strongest (local) stations will be received. The “LOC” indicator appears in the display window.
Pressing again for 2 seconds will select the Distant setting and the radio will stop at a wider range of
signals, including weaker more distant stations. The “LOC” indicator will go out on the display window.
ENHANCING THE BASS SOUND (BAS-X)....................................... 7
Press the BAS-X button 7 to display the BAS-X INDICATOR ( ) on the display window.
Each time you press the BAS-X button 7, current mode appears on the display window and the mode
change as follows.
Note
Settings for BASS, TREBLE, LOUDNESS and BAS-X can be made to each of
the following modes independently: FM, AM, and CD.
BAS-X 0 (No BASS enhanced)
BAS-X 1 (Enhanced BASS level : LOW)
BAS-X 2 (Enhanced BASS level : Middle)
BAS-X 3 (Enhanced BASS level : High)
(No display)
BAS-X 4 (Enhanced BASS level : Very high)
FXD-780GD_Ebody 03/04/2002, 04:44 pm6