Sanyo HEC-DR5000 - Tapping Motor Replacement; Massage Gearbox Replacement

- 29 -
HEC-DR5000 (GENERAL)
Replacement Procedure
(16) Replacement of Motor (Tapping)
* Take off the motor (massage) and motor
(elevation) in advance.
1, Disconnect the belt (tapping). Photo-31
2, Remove ring E 10 and pull out pulley
(tapping) from shaft. Photo-31
3, Remove one holder (magnet width) set
screw and pull out holder (magnet width)
from shaft. Photo-31
4, Remove ring C 13 from shaft. Photo-31
(17) Replacement of Gear box (Massage)
1, Remove two gear box (massage) set
screws. Photo-31
2, Remove three gear box (massage) set
screws and pull out gear box (massage)
from shaft. Photo-34
5, Remove two holder (shaft tapping) set
serews. Photo-33
6, Remove ring E 10. Photo-33
7, Remove two motor (tapping) set screws.
Photo-33
5, Remove two stay (motor massage) set
screws. Photo-32
6, Remove seven stay (A) set screws.
Photo-32
8, Move stay (A) along a shaft. Photo-34
9, Take out the moter (tapping). Photo-34
Photo-33
Holder set screw
Motor set screw
Photo-31
Belt (tapping)
Pulley (tapping)
Holder set screw
Ring E 10
Ring E 10
Ring C 13
Holder (magnet width)
Photo-32
Stay (A) set screw
Gear box set screw
Stay (Motor massage) set screw
Photo-34
Stay (A)
Gear box set screw
Gear box (massage)
Motor (tapping)