Sanyo HEC-DR7700 - Massaging (Whole Body Sensor Automatic Course); Turn the sole warmer on or off.

- 16 -
HEC-DR7700
Motor Operation Confirmation Procedure
Turn ON the POWER switch at the rear of the massager while simultaneously pressing the
POSITION ADJUST "UP" and "DOWN" buttons and "SOLE WARMER" button on the remote
controller (This operation should be started with the POWER switch turned OFF).
When the examination mode is started up, both a backrest and a foot rest move slightly and
come to a stop.
Start-up of Examination Mode
Press either " (DOWN)" or " (UP)" button of the LOWER BODY adjustment on the remote
controller. (move for 3min)
Seven motors work at the same time when they push "REPEAT" button.
Massage motor and tapping motor is fastest moves.
Elevevation motor and Strength motor goes to an upper
point and lower point and return.
Reclinning motor (foot rest/back rest/seat) repeats the expansion and
contraction.
Movement / a stop is possible with a "REPEAT" button again and again.
*When I changed massage unit assembly / reclining motore /pcb, I confirm
movement by this function.
Because Istop by an error when there is abnormality, I confirm a place of pertinence.
As for this function , sole warmer / air pump / valve moves at the same time ,too.
Air-Bag Operation Confirmation
Motor Operation Confirmation
1. Masssge motor
2. Elevation motor
3. Tapping motor
4. Strength motor
5. Reclining motor
(Seat)
<Seat under>
<Back rest>
7. Reclining motor
(Foot rest)
6. Reclining motor
(Back rest)
"REPEAT" button
1
2
2
4
4
3
1