Sanyo HEC-RX1 - Replacement of Power Switch and Current Fuse

- 13 -
HEC-FX1/RX1
Replacement Procedure
Nov./2007 Printed in Japan
SANYO Electric Co.,Ltd
Osaka, Japan
(8) Replacement of Power Switch and
Current Fuse
1, Open a fuse cover of current fuse and take
out a current fuse. Photo-16,17
2, Take off the cover (back cover). Photo-1
3, Take off the cover (front upper), the cover
(front lower) and the cover (PCB).
Photo-2,5
4, Remove each cord processing and disconnect
the cords. Photo-16
5, Remove two power supply box set screws
and take off the power supply box.
Photo-16
6, Remove four case (power supply box upper)
set screws and take off the case (power
supply box upper). Photo-17
7, Take off latches of upper and lower libs and
take off the POWER switch. Photo-18
Photo-18
POWER switch
Power cord
Photo-16
Power supply box set screws
Fuse cover
Power supply box
Photo-17
Case set screws
Case (power supply box upper)
Current Fuse