Adjusting the Picture
Adjusting the picture
To adjust the picture:
1
Press 65 to highlight an option, press 34to adjust the option;
If a sub-menu exits, press 4or OK to access. You can select:
Press MENU. The on-screen menu opens with the PICTURE
menu displayed, then press 6 to access.
!
!
!
!
!
!
!
!
!
!
!
!
!
!
Picture Mode — Selects the picture mode. You can select:
. Dynamic (a bright and vivid picture, recommended for store use. When the TV is powered on in this picture mode, a reminder
appears)
. Standard (a standard picture)
. Mild (a soft picture)
. User (user customized picture).
Note: You can also press P.MODE to select the picture mode.
Contrast — Adjusts the contrast.
Brightness — Adjusts the brightness.
Colour — Adjusts the colour saturation.
Sharpness — Adjusts the sharpness.
Tint — Adjusts the image tint. (Only for NTSC system)
Backlight — Sets the overall brilliance of the screen.
Colour Temperature — Selects the colour temperature. You can select Warm (to enhance the reds), Cool (to
enhance the blues), or Normal.
Aspect Ratio — Selects the aspect ratio of the picture. You can select:
. 16:9 — Shows a full-screen picture in 16:9 mode.
. 4:3 — Shows picture in 4:3 display mode. (Recommended not let TV remain in this mode for extended period of
time as to protect the screen.)
. Auto — Selects the correct aspect ratio automatically.
. Zoom1 — Enlarges the picture vertically. The top and bottom may be cropped.
. Zoom2 — Enlarges picture both horizontally and vertically. The edges may be cropped.
. 1:1 pixel mapping (D-SUB, HDMI only) — Displays an input source without scaling it (This option is available when
native resolution is 1920x1080 and input resolution is 1920 x 1080p)
Note: You can also press ZOOM to select the aspect ratio.
Noise Reduction — Selects the noise reduction mode to reduce picture noise (snow). You can select Low, Middle,
High, or Off.
Overscan (D-SUB,HDMI only) — Turn this On to adjust the picture’s reproduction rate (available when the TV’s
aspect ratio is in 4:3 or16:9 and the input signal is in video format).
Adaptive Contrast — Turn this On to optimize the picture display for a more vivid image.
HDMI Black Level (HDMI only) — Selects the black level on the screen. Select Low for darker screen, Normal
for brighter screen. (Available when RGB signal is input through HDMI jack).
Screen (D-SUB only) — Adjusts the computer image.
Select
Move
MENU
Return
Contrast
75
Brightness
45
Sharpness
50
Colour
50
Tint
50
Picture Mode
User
2
PICTURE SOUND TIME OPTION LOCK CHANNEL
Press the FREEZE button to freeze the image on the screen (the video sources still run). Press again to restore.
Freezing the picture
Note:
! ,
remain visible. Therefore do not freeze the picture for a long time.
! In some mode, the FREEZE function can not work.
If a fixed image is displayed on the screen for a long time that fixed image may become imprinted on the screen and
21
To Next Page
Loading...
Need help?
General
