Sanyo LED-22XR10F - Device Control Identification; TV Unit Controls (Front & Back)

Identification of Controls
Main Unit (front/side view)
1. Remote sensor
2. Power indicator
Lights blue when in operating mode.
Lights red when in standby mode.
3. POWER
4. SOURCE
To access SOURCE menu
5. MENU
Press this button to access the main menu screen.
6. CH
Press these two buttons to directly change the TV channel;
In menu operations, these buttons serve as up/down buttons.
7. VOL+
Press the VOL+ or VOL– button to directly increase or decrease
the sound volume level;
In menu operations, these buttons serve as right/left buttons.
8. Power Switch
Receives signals from the remote control.
Do not block.
Press this button to turn the unit ON from STANDBY mode. Press it
again to turn the set back to STANDBY.
^
/
^
/–
Main Unit (back view)
1. RS-232: For service only. Do not use.
2. AV OUTPUT: Connect a VCR to these jacks to record
programs.
3. USB port: Connect a USB device to this port.
4. HDMI2: Connect an HDMI device to this jack.
5. Headphone & S/PDIF:
Connect headphones to this jack.
Connect a digital sound system to this jack.
6. COMPONENT IN: Connect a component video device
to these jacks.
7. AV INPUT: Connect an AV device to these jacks.
8. RF: Connect an antenna to this jack.
9. PC IN D-SUB/AUDIO: Connect a computer to these
jacks.
10. MUSIC: Connect a MP3 player to this jack.
11. HDMI1: Connect an HDMI device to this jack.
7
SOURCE
MENU
CH VOL
+
3 4 5 6 7
Note: B
^
uttons on the TV control panel (CH / ,
^
VOL+/-, MENU, SOURCE, POWER ) are touch
buttons. First touch of the button will illuminate it.
Second touch will fulfill its function. Be sure
button presses must be quickly done before
the illumination disappears.
SOURCE MENU
CH VOL
1 2
8
HDMI 2
COMPONENT IN
USB
PB PR
RS-232
R
L
VIDEO
AUDIO
AV OUT
VIDEO
AV IN
AUDIO
S/PIDF
HD MI 1
PC IN
2
3
5
1
4
11
9 8
D-Sub
MU SI C/ AUDIO
RF
6
7
10