Sanyo LED-46XR123D - First Time Setup and Basic Operations; Initial TV Configuration Steps; Powering On;Off and Input Selection

First Time Configuration/Basic Operations
Make sure that you have inserted the batteries in the
remote control, have connected your antenna to the
TV, and have connected the AC power.
Press POWER to turn on the TV. After a few
seconds the Energy Save Mode screen opens.
Press 3or4 to select Standard/Energy Save or
Store/Dynamic, press OK to confirm. (For normal
home use, please select Standard/Energy Save.)
Now the Installation Guide screen appears with
Country Selection highlighted. Press 3or4 to
select Australia or New Zealand.
Press 6 or 5 to highlight Channel Tuning, then
press OK to begin the auto tuning for all available
ATV/DTV channels. It may take several minutes,
please wait until it is finished.
During searching, the screen will display a report
about found stations.
When complete, it will go to digital programme
position one. Now channel list has been created and
you can start to watch TV.
1
2
3
The first time you use the TV, you need to configure your TV:
Installation Guide
OSD Language
English
Channel Tuning
Select
To use this TV for displaying in a store, please select [Store/Dynamic].
[Standard/Energy Save] mode is recommended for normal home use.
Energy Save Mode
Store/Dynamic
Standard/Energy Save
OK
OK
Exit
EXIT
To configure your TV:
4
5
Turning the TV on or off
Note: If the TV does not receive a broadcast signal for several minutes, the TV goes into standby mode.
Make sure that the power cord is connected to a power outlet.
Press POWER to turn on your TV.
Press button again to turn off your TV. Your TV enters standby mode.
Warning: When the TV is in standby mode, power is still flowing into the TV. For the sake of energy saving and safety issue,
please disconnect the power cord to completely cut off the power. After you turn off the TV, you should wait some seconds
before you turn it on again.
1
2
3
Country Selection
Australia
Select
Move
13
Channel Tuning
ATV : 2 Programme(s)
DTV : 0 Programme(s)
Radio : 0 Programme(s)
2 %... 76.25 MHz (ATV)
EXIT Exit MENU Skip
Selecting the input source
To select the input source:
1
Press INPUT button. The Input Source list appears.
Press 6or 5to select the input source, then press to confirm your choice.
The TV switches to the selected source.
OK or 3/4
2
Select
Move
DTV
AV
HDMI1
HDMI2
Input Source
ATV
Component
USB
Music
HDMI3
D-SUB