Sanyo MEMO-SCRIBER TRC-6030 - Preparations and Basic Operation; Loading a Microcassette; Warning Beep Tones

Foot control
20. Back switch
(BACK)
21.
Play
switch
(PLAY)
PREPARATIONS
Connections
120VAC 60Hz
Loading
a microcassette
1. Pull the EJECT
lever to
open the
cassette compartment
lid.
2. Load
a
microcassette with
the full reel
to the right.
3. Close
the
lid
by
pressing
it.
@o
NOTES:
-
Be
sure
to close the
lid
after
loading
a
micro-
cassette.
The
unit does
not operate unless
the lid is
closed.
-
Do not
atempt to operate
the EJECT lever
while the unit
is
operating.
When
unloading
a
microcassette, first
press
the STOP but-
ton and
then
pullthe
EJECT lever to open
the
lid.
Warning
beep tones
The
unit
emits a
warning
tone in
the
following
cases:
No
cassette:
A tone sounds if there is
no cassette in
the unit
when
the unit is in the
operating
mode.
End
of taoe:
A tone
sounds
when
the tape reaches
the
end
in
all
operating
modes.
Erase
orotection:
A
tone
sounds
if
you
attempt to
erase
a
microcassette whose
erasure
guard
tab has
been broken.
#
-E3- -E4-