EasyManuals Logo

Sanyo SAP-C97GHAX User Manual

Sanyo SAP-C97GHAX
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
How to Use the Remote Control Unit
When using the remote control unit, always point
the unit’s transmitter head directly at the air
conditioner’s receiver.
Remote Control Unit Installation Position
The remote control unit may be operated either from
a non-fixed position or from a wall-mounted position.
To ensure that the air conditioner operates correctly,
DO NOT install the remote control unit in the following
places:
DO NOT
In direct sunlight
Behind a curtain or other places where it is covered
More than 8 m away from the air conditioner
In the path of the air conditioner’s airstream
Where it may become extremely hot or cold
Where it may be subject to electrical or magnetic noise
Where there is an obstacle between the remote control
unit and air conditioner (since a check signal is sent
from the remote control unit every 5 minutes)
Mounting the Remote Control Unit
Before mounting the remote control unit, press the ON/OFF
operation button at the mounting location to make sure
that the air conditioner operates from that location.
The indoor unit should make a beeping sound to indicate
that it has received the signal.
To take out the remote control unit, pull it forward.
When Holding the Remote Control Unit
When using the remote control unit and during air
conditioner operation, the transmitter on the remote
control unit should be pointed toward the receiver
on the indoor unit.
Make sure that there are no objects between
the remote control unit and receiver which could
block the signal.
To prevent loss of the remote control unit,
you can connect the remote control unit
to the mount by passing a string through
the remote control unit and attachment hole.
To remove the remote
control unit, slide it upward.
Insert the remote
control unit from
the top.
Remote control
unit mount
Mounting screws 4 x 16 (included)
Rear side
Hole
Receiver
Air conditioner
(Indoor unit)
Remote control
unit
(Transmitter head)
Using the Remote
Control Unit
How to Install Batteries
1. Slide the cover in the direction indicated by the arrow
and remove it.
2. Install two AAA alkaline batteries. Make sure the
batteries point in the direction marked in the battery
compartment.
3. Use a thin object such as the tip of a pen to press
the ACL button.
The batteries last about six months,
depending on how much you use the
remote control unit. Replace the batteries
when the remote control unit’s display
fails to light, or when the remote control
cannot be used to change the air condi-
tioner’s settings.
Use two fresh leak-proof type-AAA
alkaline batteries.
In replacing batteries, follow the instruc-
tions as mentioned in the sub-section
“How to Install Batteries”.
If you do not use the remote control unit
more than 1 month, take out the batteries.
NOTE
ACL button
8

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo SAP-C97GHAX and is the answer not in the manual?

Sanyo SAP-C97GHAX Specifications

General IconGeneral
BrandSanyo
ModelSAP-C97GHAX
CategoryAir Conditioner
LanguageEnglish

Related product manuals