Sanyo SAP-CRV12AEH - Page 50

Flap motor
(5) Take off wiring terminal. (Fig.28)
(6) Remove display P.C.Board assy. (Fig.29)
(7) Remove flap motor. (Fig.30 and Fig31)
(8) To remove the control P.C.Board unfasten the 2 hooks at the upper part from the rear side. (Fig.32)
 The control P.C.Board is integrated with the power supply P.C.Board.
(9) Lift up the upper part of the control P.C.Board and remove it. (Fig.33)
Fig. 30 Fig. 31
Fig. 32 Fig. 33
Fig. 28 Fig. 29
Display PCB ASSY
NOTE
Control PCB
50