Sanyo SPW-C253GH5 - Page 86

SM830035
– 86 –
4
4. Service procedures
This picture shows the service check display.
For example, if the last four alarm messages were, in order of occurrence from oldest to
most recent, P01, P02, P04, and most recently E01, then the display will be shown as
below when you press button four times. The 5th time you press button you can
repeat the display, then the first message will be shown again.
c. A maximum of 4 alarm messages can be accessed by pressing either SET TEMP
button or as follows.
SERVICE
R.C. No.
CHECK
UNIT No.
No.CODE
0358_M_I
CODE No.
No.
UNIT No.
1–1
Alarm message
Refrigerant
Circuit No.
0359_M_I
Present
Past
Present
Past
MODE
FAN SPEED
SET TEMP.
NOTE Pressing CL (Clear) button will clear all
the service history.
... accessed in order of “Past È Present”.
... accessed in order of “Present È Past”.
0360_M_I
SERVICE
R.C. No.
CHECK
UNIT No.
No.CODE
SERVICE
R.C. No.
CHECK
UNIT No.
No.CODE
SERVICE
R.C. No.
CHECK
UNIT No.
No.CODE
SERVICE
R.C. No.
CHECK
UNIT No.
No.CODE
SERVICE
R.C. No.
CHECK
UNIT No.
No.CODE
If there are no alarm messages, the display shows:
Alarm message
1234