Need help?Do you have a question about the Sanyo SR-2570M and is the answer not in the manual?
General| Brand | Sanyo |
|---|---|
| Model | SR-2570M |
| Category | Refrigerator |
| Language | English |
Wash interior liner with baking soda solution, rinse and wipe. Avoid soaps/detergents for odor prevention.
Wash ice cube trays, drip tray, and shelves with mild detergent. Dry with a soft cloth.
Wipe exterior with damp soapy cloth, then dry. Appliance cleaners okay for exterior only.
Clean door gasket using only mild soapy water.
Never use acids, thinners, gasoline, or benzene. Boiling water/benzene can damage plastic parts.
Regulate refrigerator temperature by rotating the cold control knob clockwise towards MAX.
Temperature varies with food quantity and door opening frequency. Use MAX for quick ice.
Expect more frequent on/off cycles due to the refrigerator's compact size.
Defrost when ice layer on the freezing compartment wall reaches a quarter inch thick for efficient operation.
Remove food, place drip tray, and set cold control knob to 'OFF' to start defrosting.
Speed up defrosting by removing food, opening the door, and using warm water on frosted areas.
Do not use sharp tools, boiling water, or heaters. These can damage plastic parts and void warranty.
Empty drip tray, then set cold control between 'MAX' and 'MIN' to restart refrigeration.
Identifies parts of the SR-257 model including ice storage, drip tray, controls, shelves, and racks.
Identifies parts of the SR-366 model including freezer, drip tray, controls, shelves, and racks.
The unit has a PTC device. Wait 3 minutes before restarting or plugging in after it's turned off.
Install in a cool, dry, level place with adequate air circulation, away from direct sunlight and heat.
Ensure 4 inches rear, 1 inch sides, and 12 inches top clearance for proper operation and air circulation.
Use a grounded outlet. The refrigerator has a three-prong plug. Do not use an extension cord.
Plug in with cold control at 'OFF'. The motor should not run.
Set control to 'MAX', run for 20 mins. Check for slight frosting and smooth motor operation.
Rotate control counter-clockwise to 'MIN'. Motor should stop before reaching 'MIN'.
Twist the flexible ice cube tray to release the cubes.
Do not use boiling water or metal tools like knives/screwdrivers, as they may damage plastic parts.
To Next Page