Sanyo VCC-4594P - Page 16

NOTE:
1. N.S.P. : Not available as service parts.
2. All resistance values in "OHMS" unless otherwise noted.
(K=1,000 ; M=1,000,000)
3. All inductance values in "
µµ
µµ
µH" unless otherwise noted.
µµ
µµ
µ , u or U=micro henry ; m=milli henry
4. All capacitance values in "
µµ
µµ
µF" unless otherwise noted.
p=pico farad ;
µ µ
µ µ
µ , u or U=micro farad
5. Voltage reading may vary
±20%.
6. This is a fundamental circuit diagram, some production
changes may be made without revision of the diagram.
PRODUCT SAFETY NOTICE
PRODUCT SAFETY SHOULD BE CONSIDERED WHEN COMPO-
NENT REPLACEMENT IS MADE IN ANY AREA OF A UNIT COMPO-
NENTS INDICATED BY THE SYMBOL IN THIS SCHEMATIC DIA-
GRAM SHOW COMPONENTS WHOSE VALUE HAVE SPECIAL SIG-
NIFICANCE TO PRODUCT SAFETY IT IS PARTICULARLY RECOM-
MENDED THAT ONLY PARTS SPECIFIED ON THE ATTACHED
PARTS LIST BE USED TO COMPONENTS REPLACE DESIGNATED
BY THE SYMBOL .
NA_C_EX
EXPLANATORY NOTES (EXAMPLES)
Resistor 10K:1/16J means 10kilo ohm
±5%, 1/16watt max.
1M:1/10K means 1mega ohm
±10%, 1/10watt max.
Capacitor 0.047:F means 0.047micro farad, Ftype.
Electrolytic capacitor
10:16 means 10micro farad, 16volt max.
Inductor 330:J means 330micro henry
±5%
470:K means 470micro henry
±10%
No description J or K means
±5%