Sanyo VCC-HD5600P User Manual

VA-94S
SUMMARY/SETUP MANUAL
Power Board Unit
VCC-MCH5600
VCC-MCH5600P
Megapixel Camera
THIS INSTALLATION SHOULD BE MADE
BY A QUALIFIED SERVICE PERSON AND
SHOULD CONFORM TO ALL LOCAL
CODES.
(Power Boad Unit)
(Megapixel Camera)
EnglishFrançaisEspañolDeutschЁ᭛ㅔԧ
Before installing and using the camera, please read
this manual carefully.
Be sure to keep it handy for later reference.
In addition, be sure to read carefully the electronic
manual (INSTRUCTION MANUAL) contained in the
supplied CD-ROM to ensure correct operation of
the camera.

Important
Be careful when opening holes for installing
the unit. Work with the power and video cables
pulled out for easy installation.
Make sure to properly perform waterproofi ng for
the ceiling where you are installing the unit.
Make sure that the surface in the installation
location has no unevenness and is strong
enough to bear the total weight of the unit.
Install this unit in an environment where the
temperature range stays between –10°C and
+50°C/14°F and 122°F (no condensation
allowed).
As a precaution against static electricity
damage, touch a nearby metal object (door
knob, etc.) to dissipate static electricity in your
body before touching this unit.
•
•
•
•
•
L5DD2VA-94SMCH5600PGB.indd1L5DD2VA-94SMCH5600PGB.indd1 2009/10/2312:06:212009/10/2312:06:21

Sanyo VCC-HD5600P Specifications

General

Brand	Sanyo
Model	VCC-HD5600P
Category	Security Camera
Language	English

Summary

Installation Guide

Power Board Unit Installation

Steps for installing the power board unit, including drilling holes and securing it to the ceiling.

Camera Unit Mounting

Instructions for fastening the camera unit safety wire and attaching the camera to the power unit.

Drop-Prevention Cable Attachment

Procedure for attaching the accessory drop-prevention cable to the camera unit.

System Connections

Power Connection

Details on connecting the 24 VAC power supply to the power terminal.

Audio Jack Connections

Guide for connecting audio output (black) and audio input (white) jacks.

Network Connection Setup

Instructions for connecting the camera to a network via LAN for remote operation.

Recording Media Installation

Information on installing SD memory cards or external hard disks for recording.

Control Terminal Connections

Connecting alarm input/output cables and controllers to the interface board.

Alarm Signal Output

Connecting alarm devices like buzzers or lamps to the alarm output terminals.

Alarm Signal Input

Connecting alarm switches or sensors to the alarm input terminals.

Controller Connection

Connecting a system controller for remote camera control.

Control and Address Settings

Control Switch Configuration

Setting transmission rate and protocol using the control switch.

Baud Rate Settings

Configuring the transmission rate to match connected devices.

Protocol Selection

Choosing the camera control protocol (SSP or PELCO).

Address Switch Configuration

Setting unique RS485 addresses for multiple cameras.

Address Settings Table

Network Operation Setup

Specifications Overview

Copyright and Legal Information