If video is out of focus in either color or black-and-white mode, perform the following steps to adjust
the focus.
1 Confirm that [COLOR/B/W] is set to “AUTO” under [FOCUS ASSIST] on the CAMERA SETTINGS
screen.
2 Adjust the focus in color and black-and-white mode, respectively.
If you are using an optical zoom lens and zooming operation causes the camera to lose focus, adjust the flange
back distance as follows.
1 Press the SET button for 2 seconds or more.
The monitor now shows the SELECT MENU screen.
On the SELECT MENU screen, all information is displayed in English.
2 Select [FOCUS ASSIST] using the NEAR/FAR button and press the SET button.
The monitor now shows the focus adjustment screen.
3 Use the zoom and focus levers of the lens to focus on the subject at the telephoto end
and press the NEAR/FAR button to adjust the focus.
Pressing the button causes the back focus position to change, which is indicated in the FB bar gauge ( C ).
The position changes step by step each time the button is pressed and continuously at a high speed when the
button is held down.
4 Use the zoom and focus levers of the lens to focus on the subject at the wide end and
press the NEAR/FAR button to adjust the focus.
Repeat the above steps until switching between the telephoto and wide ends does not cause the camera to lose
focus.
Introduction 15
To Next Page
Loading...
