The setting values are interlocked among RECORDING, E-MAIL SETTINGS, and FTP SETTINGS
screens. (Note that the setting configured most recently will take precedence.)
B [DURATION] setting in case you selected “ALARM IN1/2”, “MOTION”, “ALARM OUT1/2”, or
“NETWORK FAILURE”
In [DURATION], select the image transmission duration.
5SEC, 10SEC, 20SEC, 40SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN, 10MIN, 15MIN
C Common setting (INTERVAL)
In [INTERVAL], select the interval between e-mail transmissions.
1SEC, 2SEC, 3SEC, 5SEC, 10SEC, 30SEC, 1MIN, 3MIN, 5MIN, 10MIN, 15MIN, 30MIN, 1HOUR, 2HOUR,
3HOUR, 4HOUR, 5HOUR, 6HOUR, 8HOUR, 12HOUR, 24HOUR
If you selected “ALARM IN1/2”, “MOTION”, “ALARM OUT1/2”, or “NETWORK FAILURE”, only
“1SEC-15MIN” is displayed as an option.
In [INTERVAL], the pull-down menu will only show options that do not exceed the [DURATION]
setting.
2 In [JPEG IMAGE], select the JPEG stream you want to send and click SET .
You can send JPEG images only.
You need to configure the video conditions for each stream on the VIDEO & AUDIO SETTINGS
screen.
The pull-down menu shows a list of streams for which you selected “JPEG” in [CODEC] on the
VIDEO & AUDIO SETTINGS screen.
A warning message will appear if there is no JPEG stream available.
Workin
To Next Page
Loading...
