Use the / button to select [PRIVACY MASK] in the main menu, and press the SET button.
The MASK NO. SELECT screen appears.
Use the / button to select [MASK 1].
Use the / button to choose “SET” in [MASK 1], and press the SET button.
The MASK 1 SET [POSITION] screen appears and the mask pattern is displayed in the center of the screen.
Use the buttons to move the mask pattern to determine the position to be covered, and
press the SET button.
The MASK 1 SET [SIZE] screen appears.
Use the buttons to adjust the vertical and horizontal sizes of the mask pattern, and
press the SET button.
This completes the privacy mask settings. The MASK NO. SELECT screen appears again, and the setting for
[MASK 1] has been changed to “ON”.
Repeat the same procedures above to set MASK 2 to MASK 4, as necessary.
1
2
3
4
5
If any other privacy masks have already been set, they are displayed together in the setting screens.
The numbers following the right arrow (
→
) at the bottom of the screen indicate the set mask
56 / 100
To Next Page
Loading...
