Sanyo VCC-XZ600P - Enabling Password Lock (PASSWORD LOCK)

Use the / button to select [PASSWORD] in the main menu, and press the SET button.
The PASSWORD screen appears.
Use the / button to select [PASSWORD LOCK], and press the SET button with “OFF
↓
”
displayed.
The password entry screen appears.
Use the / button to select the digit and use the / button to select a number for the digit.
Repeat this procedure until the whole password value (ex. 1234) is entered, and press the SET
button.
When a valid password is entered, “OK” appears.
Press the SET button again.
This completes the password lock setting, and the PASSWORD screen appears again.
While the password lock is enabled, “ON” is displayed for [PASSWORD LOCK].
Select [MENU] and choose “BACK” or “END” to complete the setting.
1
2
3
When a wrong password is entered, “NG” appears.
If you enter wrong passwords three consecutive times, the password entry field disappears.
4
5
60 / 100