Sanyo VCC-XZ600P - Page 82

Set addresses to individual cameras. (OPTION
→
SYSTEM)
Set an unique title to each camera. (OPTION
→
DISPLAY
→
TITLE)
Select a communication mode in the [CONTROL] option. (OPTION
→
SYSTEM)
Set addresses to individual cameras. (OPTION
→
SYSTEM)
When you want to output the alarm signal from the camera to the system controller, set the [LINE OUT]
option to “ON”. (ALARM
→
ALARM IN)
Perform the input setting for the control terminal (ALARM IN).
Perform the output setting for the control terminal (ALARM OUT).
82 / 100