Sanyo VPC-E1403 - Drive Mode Settings; Setting the Drive Mode

37
Setting the Drive Mode
Your camera features a Self-timer and Burst which can be set
in the Drive mode function in the Record Menu. The Self-timer
allows you to take images after a pre-defined delay. While
burst lets you take consecutive shots. This function is only
available in recording still images. The Drive mode setting is
automatically set to off when you turn off the camera.
To set the Drive Mode
1. From the Record menu, select Drive Mode.
2. Use the
or keys to go through the selection.
3. Press the SET button to save and apply changes.
The table below shows the available Drive mode settings.
Icon Item Description
10 Sec. Sets a 10-second delay to capture image after pressing the Shutter button.
2 Sec. Sets a 2-second delay to capture image after pressing the Shutter button.
Double
Performs delay and capture twice:
• Performs a 10-second delay, then captures the image.
• Performs another 2-second delay then captures the image again.
Burst
Performs continuous shooting when the Shutter button is pressed.
Stops shooting when the Shutter button is released.
Speedy Burst
Captures 30 images in a shot when the Shutter button is pressed.
Auto set Image size to VGA only.
Off Captures an image without time delay.