Need help?Do you have a question about the Saramonic UwMic9S Kit2 and is the answer not in the manual?
General| Modulation | FM |
|---|---|
| RF Output Power | 10 mW |
| Audio Frequency Response | 50 Hz - 18 kHz |
| Pilot Tone | Yes |
| Battery Life | Up to 8 hours |
| Type | Wireless Microphone System |
| Operating Range | 100 m (line of sight) |
| Audio Output | 3.5mm Output |
| Battery Type | AA batteries (not included) or rechargeable batteries |
| Charging Time | Not applicable |
| Compatibility | DSLR cameras, camcorders, audio recorders, smartphones, tablets, and more |
| Included Components | Transmitter, receiver, lavalier microphone, cables, and carrying case |
| Frequency Range | 514 - 596 MHz |
Read manual carefully, operate and store according to instructions.
Important safety precautions for operating and storing the wireless microphone system.
Overview of the Saramonic UwMic9S UHF wireless microphone system's intended use.
Introduction to the portable wireless receiver unit.
Diagram and labels identifying the components of the portable receiver unit.
Details on receiver buttons, switches, mounting adapter, and charging port.
Explains receiver's home screen, group status, RF/battery levels, and audio meter.
Power key lock, output mode, input mode, and low cut function settings.
Settings for local mic gain and input type (Enable/Disable).
Adjusting microphone gain, auto scan, channel selection, and output volume.
Infrared matching to transmitter and receiver backlight settings.
Introduction to the camera-mountable body-pack transmitter unit.
Diagram and labels identifying the components of the body-pack transmitter.
Details on transmitter buttons, ports, and accessory attachment.
Explains transmitter home screen elements: group, mute status, battery, channel/frequency.
Operations for locking/unlocking power key and enabling/disabling mute function.
Selecting channels and adjusting microphone sensitivity for the transmitter.
Infrared matching to receiver and restoring transmitter to default settings.
Adjusting backlight settings and viewing the transmitter's firmware version.
Procedure for automatically scanning and selecting optimal RF channels.
Manual procedure for setting the receiver channel using the +/– buttons.
Using infrared to match the receiver's frequency with the transmitter.
Technical details for the receiver, including channel number, frequency, and dimensions.
Technical details for the transmitter, including channel number, frequency, and dimensions.
List of all components included in the UwMic9S Kit2 package.
Device compliance statement and warnings regarding interference and modifications.
Guidelines to ensure compliance and mitigate potential radio interference.
Statement on the device's evaluation for RF exposure requirements.
To Next Page
