39
How to resolve problem or other details
In this state nothing is paired and the trainer will
simulate the power curve of our Fluid2 trainer.
This state is entered after being paired and
receiving the rst ANT+ FE-C command. It will not
return to green until power is cycled.
Often an app on a device has connected to the
trainer as a power meter.
Some apps will connect to the trainer but not
issue a control command, which would also leave
the trainer in this state.
When the device disconnects from the trainer the
LED returns to blinking green.
A device has connected and issued a control
command.
Will not return to blinking blue from this state.
When the device disconnects from the trainer the
LED returns to blinking green.
LED Color Blink Rate Meaning How to resolve problem or other details
Blue/
White
Red
Red
Red
Red
N/A
Hz
Solid
1Hz
2Hz
4Hz
N/A
NT+ FE-C controlling. Bluetooth device
connected (as power meter) but not controlling.
Microprocessor is being updated
Microprocessor update failed
Microprocessor has failed
Radio communication error
Radio Temperature Limit Reached
Coil Temperature Limit Reached
Unplugged or sleeping
Combination of two states listed above.
Wait for update to nish
Retry rmware update
Contact customer service.
Contact customer service.
Should not occur under most normal operating
conditions. However, you can try allowing the
trainer to cool o. When the temperature drops
below the threshold the LED will return to normal.
Should not occur under most normal operating
conditions. However, you can try allowing the
trainer to cool o. The trainer will need to be
power cycled in order to recover.
If plugged in, start pedaling to wake trainer up.
1Hz = 1 blink/second 2Hz = 2 blinks/second 4Hz = 4 blinks/second
For these blinking combinations the H2 or M2 trainer must have rmware v31.31 or newer
29263B_Saris M2 Trainer Manual_indesign file-PLK.indd 3929263B_Saris M2 Trainer Manual_indesign file-PLK.indd 39 2/1/2021 2:29:46 PM2/1/2021 2:29:46 PM
To Next Page
Loading...
