39
Preparation
Set parameters for the Counting program:
$ Select the application program in the Setup menu
§ Set the following parameters:
2 Application programs
2 1 Program selection
2 1 4 Counting
3 Application parameters
3 5 Storage parameter
3 5 1 Standard resolution
(internal resolution)
3 5 2 ο 10 x higher resolution
4 Application parameters for Counting
4 1 Autom. ref. sample updating
4 1 1 o Off
4 1 2 On
8 Extra functions
8 8 Reference balance/scale
8 8 1 o Off
8 8 2 On for QC scales
8 8 3 On for FB-/FC-/LA-/LP models
8 8 4 On for isi terminals
o= Factory setting
Printout: Counting
nRef + 10 : Reference sample quantity
wRef + 21.14 g : Reference weight
Qnt + 500 pcs : Calculated quantity
To Next Page
Loading...
Need help?
General
