18
In order to ensure the failure-free and safe operation (to maximum extent) the
controller of boiler is provided with many protection functions. If faulty status is
discovered, the alarm is launched (acoustic signal), and a message is shown on
display (depending on controller version).
TRMAL PROTECTION
The controller is equipped with safety temperature limiter, preserving the boiler
against overheating (boiling water in installation), if the controller is damaged.
Temperature limiter makes up mechanical protection measure, which bimetallic
sensor (placed at the boiler water temperature sensor) is cutting off power supply to
blow-in fan, if temperature is higher than 90°C (p ump still working).
TEMPERATURE PROTECTION
The controller is equipped with additional temperature protection (electronic one),
for the case of bimetallic sensor is faulty. If temperature of 95°C is exceeded, cutting
off power supply to blow-in fan is executed.
SAFETY VALVE
The boiler is equipped with connector for adapting a safety valve, being an
additional protection against pressure raise due to water freezing in part of
installation, especially in the pressure vessel. The safety valve is not supplied with the
boiler.
Commercially delivered boilers are assembled and supplied with complete set
of tools for maintenance together with the technical-start-up documentation.
Before connecting a boiler to a heating installation, make check if all boiler’s
components are in good working condition, and that the boiler is fully equipped.
NOTE: Boilers need to be transported in the vertical position!
In order to recycle the boiler worn device deliver to specialized recycling unit,
according to detailed regulations being in force in the country of destination.
To Next Page
Loading...
Need help?
General
