Transporting the machine in a car, please empty the fuel tank completely first to avoid the
leakage.
Empty the fuel
1. Place the machine on even and stable surface. Warm up the engine for several minutes and
then stop it.
2. Loosen the fuel tank cap and remove it.
3. Drain fuel into a container thoroughly.
4. Press the intake pump several times until fuel begins to empty the bulb.
5. Drain fuel again.
6. Reinstall the fuel tank cap.
Transport and storage the machine, use protective gloves when handling the blades.
Keep the blade protection device on, except when intervening directly on the blade.
Store the machine, operating instructions and where necessary the accessories in the original
packaging. In this way you will always have all the information and parts ready to hand.
Pack the device well or use the original packaging in order to avoid transit damage.
Store the machine in dry and well ventilated surroundings and with the fuel tank empty. Do not
store fuel next to the machine.
To Next Page
Loading...
General