Example of setting the default 7 day schedule with 6 switches. Check table two for reference.
1. Enter the editing mode by briefly pressing the P button.
2. The day flashes, then press or to select the day you want to edit. Confirm the selection by briefly
pressing the P button.
3. The time is blinking now. Press or key to select the desired time to start the time program. Confirm
the selection by briefly pressing the P button.
4. The temperature is now flashing. Press or button to select the desired temperature of the time
program. Confirm the selection by briefly pressing the P button.
5. Now you have finished editing the first of the six time programs for the selected day, the clock is flashing,
and the next time program (switch) editing is started. By briefly pressing the R key, you can finish editing
the program / schedule or continue by briefly pressing P to edit another time program, following the same
steps from 2-4.
When you are finished with the sixth time program, you will switch to editing the next day after the same
steps 2-4.
Once you have finished editing the heating programs, just confirm with briefly pressing the R key. If you do not make
any changes within 30 seconds all the settings are saved.
To Next Page
Loading...
Need help?
General
