WARNING！Electrical Shock Hazard
Turn off power at the main service panel by removing the fuse or
switching the appropriate circuit breaker to the OFF position before
removing the existing thermostat.
1. Turn off power to the heating and cooling system by removing the
fuse or switching the appropriate circuit breaker off.
2. Place the system switch (HEAT/OFF/COOL) in the OFF position.
3. Place the FAN (ON /AUTO) switch in the AUTO position.
4. Gently pull the cover straight off the base. (See figure 1.)
5. Put the thermostat base against the wall where you plan to mount it.
(Be sure the wires will feed through the wire opening in the base of the
thermostat.)
To Next Page
Loading...
