To Next PageTo Next PageWhat to do if round/flat fan control cannot be regulated on SATA SATAjet 5000 B RP Paint Sprayer?
If the round/flat fan control on your SATA Paint Sprayer cannot be regulated, the regulation valve might be dirty. Remove the round/flat spray control and repair or replace it.
What to do if my SATA Paint Sprayer does not shut-off air?
If your SATA Paint Sprayer does not shut off air, the air piston seat might be clogged, or the air piston worn. Clean the air piston seat and/or replace the air piston and air piston packing.
Why are there air bubbles in the gravity flow cup of my SATA Paint Sprayer?
If you observe air bubbles appearing in the gravity flow cup of your SATA Paint Sprayer, several factors could be at play. First, check if the air cap is loose and tighten it by hand. Second, a gap between the air cap and fluid tip (the air circuit) might be clogged, requiring cleaning. Third, the nozzle set could be clogged or damaged, in which case you should clean or replace it. Fourth, ensure there's enough paint material in the gravity flow cup and refill if necessary. Finally, a defective paint needle sealing could be the culprit, necessitating its replacement.
Why round/flat fan control cannot be regulated on SATA Paint Sprayer?
If the round/flat fan control on your SATA Paint Sprayer cannot be regulated, the regulation valve may be dirty. Remove the round/flat spray control and repair or replace it.
What to do if round/flat fan control has no function on SATA Paint Sprayer?
If the round/ flat fan control on your SATA Paint Sprayer is not functioning but the control knob can still be turned, it could be that the air distribution ring has not been positioned in the correct location (the pin is not located in the drillings) or it is damaged. Replace the air distribution ring, making sure it has been positioned correctly when inserting it.
General| Recommended Inlet Pressure | 2.0 bar |
|---|---|
| Type | HVLP |
| Working Pressure | 2.0 bar |
| Material | Aluminium |
| Fluid Inlet | 1/4" |
| Air Inlet | 1/4" |
| Spray Pattern | Circular, Horizontal, Vertical |
Emphasizes reading instructions carefully and keeping documents with the product for safe operation.
Covers essential safety rules like not pointing the gun at people, skilled personnel use, and avoiding damaged parts.
Guides on setting the correct spray gun inlet pressure using various methods for optimal performance.
Instructions for replacing the complete nozzle set, ensuring proper lubrication and adjustment.
Guides on how to replace the air distribution ring using specific tools and checking sealing surfaces.
Details the process for replacing the paint needle sealing to prevent material leaks and ensure proper function.
