Satel CA-10 - Page 2

WARNINGS
Due to safety reasons, alarm system should be installed by qualified personnel only.
Telephone terminals of the panel should be connected to PSTN lines only. Connecting to
ISDN lines may lead to damage of the equipment.
Because alarm system may contain hazardous items, its components should be kept out of
reach of unqualified personnel.
In order to avoid the risk of electric shock, read carefully this manual before proceeding to
installation. Any connections should be made in deenergized state only (i.e. with power
supply disconnected).
In the event of service operations consisting in fuse replacement, they must only be carried
out after disconnecting the supply voltage. For the replacement, use only the fuses which
have identical parameters as the original ones.
It is recommended that the manufacturer’s required housings and power supply units be
used.
Making any construction changes or unauthorized repairs is prohibited. This applies, in
particular, to modification of assemblies and components.
CAUTION !
It is impermissible to connect a fully discharged battery (voltage on terminals without a load
less than 11V) to the alarm panel. To avoid hardware damage, fully discharged or never used
battery should be precharged using proper charger.
The batteries used in the alarm systems contain lead. The old batteries must not be thrown
away, but disposed of as required by the existing regulations (European Directives
91/157/EEC and 83/86/EEC).
DECLARATION OF CONFORMITY
Product:
CA10P – Control panel CA-10
mainboard
Manufacturer: SATEL spółka z o.o.
ul. Schuberta 79
80-172 Gdańsk, POLAND
tel. (+48 58) 320-94-00
fax. (+48 58) 320-94-01
Product description: Mainboard for CA-10 control panel intended for use in intruder alarm systems.
This product meets the essential requirements and is in conformity with following EU Directives:
LVD 73/23/EEC+93/68/EEC
EMC 89/336/EWG + 91/263/EEC, 92/31EEC, 93/68/EEC
R&TTE 1999/5/EC (network connection, TBR21)
This product is compliant with the following harmonized standards:
LVD: EN 50131-1:1997; EN 50131-6:1997; EN60950:2000, EN60335-1:1994/A1:1996 Annex B
EMC: EN 55022:1998; EN 61000-3-2/-3; EN 50130-4:1995, EN 61000-4-2/-3/-4/-5/-6/-11
R&TTE: TBR 21(1998)
Compliance with harmonized standards was checked in an accredited test house: "Electronic
Technology Systems Dr. Genz GmbH", Germany.
LVD test report no: G0M20211-7294-L
EMC test report no: G0M20211-7294-E-16
R&TTE test report no: G0M20211-7291-T-15 (TBR21)
Gdańsk, Poland 06.05.2004
Head of Test Laboratory:
Michał Konarski
Latest EC declaration of conformity and product approval certificates can be downloaded from web site
www.satel.pl