Need help?Do you have a question about the Satel Integra 32 and is the answer not in the manual?
Instructions for programming the control panel using its keypad interface.
Procedure to enter the control panel's service mode using a keypad.
Emergency procedure to enter service mode via hardware pins when keypad access fails.
Configuration of identifiers and communication settings for DLOADX.
Setting unique identifiers for the control panel and DLOADX program for connection.
Configuration of modem settings for remote communication.
Configuration of Ethernet module settings for network communication.
Configuration of GSM/GPRS module settings for cellular communication.
Steps for programming the control panel directly via RS-232.
Methods for programming the control panel remotely via modem, Ethernet, or GSM.
Dividing the system into separate armed/disarmed areas.
Defining protected areas monitored by detectors.
Detailed settings for GSM module, including PIN, PUK, modem, and GPRS.
Settings for keypad display, functions, and behavior.
System-level settings for ABAX, including assigned partition and response period.
Configuration of individual ABAX wireless devices (detectors, sirens).
Detailed configuration of wireless devices using the DLOADX software.
General settings for event reporting and communication paths.
Settings for reporting stations, dual path, and advanced options.
Configuring reporting details for primary and secondary monitoring stations.
Settings for SMS reporting specific to the INTEGRA 128-WRL.
Procedures for initiating different reporting methods.
General settings for messaging and defining content.
Configuring SMS commands for zone violation, functions, and status checks.
General| Zones | 32 |
|---|---|
| Partitions | 4 |
| Communication buses | RS-232, RS-485 |
| Battery backup | 12 V, 7 Ah |
| Operating temperature range | -10°C to +55°C |
| Number of telephone numbers | 4 |
| Power supply | 12 VDC |
| Communication | PSTN |
To Next Page
