Satel Integra 32 - Entering Data by Means of the Keypad

SATEL INTEGRA 25
Tamper in part.
EOL Rp resistor
AC loss delay
CA-64 EPSi (v. 4.00)
No autorst.3t.
Tamper in part.
EOL R1 resistor
EOL R2 resistor
AC loss delay
INT-EPS / INT-IORSPS / INT-PPPS
No autorst.3t.
Tamper in part.
EOL R1 resistor
EOL R2 resistor
AC loss delay
INT-KNX
No autorst.3t.
Partition
KNX control
Out addresses
Outputs
Telegrams
Factory sets
INT-AV
INT-AV code
Verify s1A
Code=1tone s1A
Verify s1B
Code=1tone s1B
Verify s2A
Code=1tone s2A
Verify s2B
Code=1tone s2B
Options
Microphone n [n = microphone number (1...4)]
Speaker n [n = speaker number (1...4)]
Only listen
AVT buttons
Sound signal.
Silent alarm
Satel commands
Wait aft.event
Wait aft.disc.
Runtime
No autorst.3t.
Tamper in part.
2.6 Entering data by means of the keypad
Data are saved to the control panel if you press the key (in some keypads, the key is
also available, whose function is exactly the same). The key enables exiting the function
without saving any changes.