Need help?Do you have a question about the Satel Integra Plus Series and is the answer not in the manual?
Programming control panel using keypad (real or virtual).
Procedure to enter service mode using service code or shortcut.
Emergency procedure to start service mode using hardware pins.
How to exit service mode and save settings.
Overview of the DLOADX program's main interface and functions.
Step-by-step guide to start local programming using DLOADX.
Guide to setting up remote programming using a modem.
Steps to establish remote programming via Ethernet network.
Steps to establish remote programming via GPRS.
Defines objects as separate alarm systems and how to create new ones.
Separated areas within the premises protected by the alarm system.
Details on partition parameters and user authorization.
How to assign zones to a partition using keypad or DLOADX.
How to program zones using keypad or DLOADX.
Parameters for zones like name, partition, and type.
Lists and describes various types of zones.
Defines output name and cut-off time.
Lists and describes various functions of outputs.
Defines output operating modes like polarity, pulsating, latch.
Specifies how zones control output events.
Presents output status based on zone status.
Using virtual outputs for logical AND/OR functions.
How to test outputs using the service mode menu.
Configuration of telephone reporting and messaging options.
Settings related to printer output and configuration.
Miscellaneous system configuration options.
Options related to system arming behavior.
Time-related parameters for system functions.
Options and parameters for service mode access.
Sets address of NTP server for time synchronization.
Tests network communications using PING.
Key for encrypting data over Ethernet.
Names and settings for LCD keypads.
Partitions controllable from the keypad.
Defines functions executed by user code and arrow keys.
Defines which alarms are triggered from the keypad.
Shortens exit delay by pressing 9# keys.
Sets timer activation/deactivation times.
Sets exception times for timer activation/deactivation.
Individual name for user schedules (up to 16 characters).
Timers determining user access to the system.
Parameters and options for reporting events to monitoring stations.
Selects monitoring stations for event code transmission.
Advanced settings for reporting formats.
Assigns identifiers to events sent to monitoring stations.
Parameters for sending events in SIA-IP format.
Assigns identifiers to system elements.
Steps to initiate and configure event reporting.
Steps to enable and configure telephone reporting.
Steps to enable and configure Ethernet reporting.
Steps to enable and configure GPRS reporting.
Parameters and options for voice/pager messages.
Defines names and numbers for messaging.
Assigns events to specific messages and telephones.
Cancels messaging for specific partitions or telephones.
Parameters and options for SMS messaging.
Selects events for SMS notification.
Steps to initiate voice messaging.
Parameters and options for telephone answering and control.
Links answering/control to partition armed status.
Assigns remote switch outputs to users.
Steps to activate phone call answering.
Steps to activate remote control functions.
General| Power Supply | 12 VDC |
|---|---|
| Timers | Yes |
| Communication | Ethernet, GSM, PSTN |
| Battery Backup | Yes |
| Certification | EN 50131 Grade 3 |
| Communication Buses | RS-485 |
| Model | Integra Plus Series |
To Next Page
