WARNINGS
In order to avoid the risk of electric shock, read carefully this manual before proceeding to
installation. Any connections should be made in deenergized state only (i.e. with power
supply disconnected).
For safety reasons, the alarm system should only be installed by qualified personnel.
Telephone terminals of the panel should be connected to PSTN (analog) lines only.
Connecting to ISDN lines may cause damage to the equipment.
As the alarm system may contain hazardous items, its components should be kept out of
reach of unqualified personnel.
In the event of service operations consisting in fuse replacement, they must only be carried
out after disconnecting the supply voltage. For the replacement, use only the fuses which
have identical parameters as the original ones.
It is recommended that the manufacturer’s required housings and power supply units be
used.
Making any construction changes or unauthorized repairs is prohibited. This applies,
in particular, to modification of assemblies and components.
CAUTION!
It is impermissible to connect a fully discharged battery (with voltage on unloaded terminals
less than 11 V) to the alarm panel. To avoid hardware damage, the fully discharged or never
used battery should be precharged with the use of a suitable charger.
The batteries used in the alarm systems contain lead. The used-up batteries must not be
thrown away, but disposed of as required by the existing regulations (European Directives
91/157/EEC and 83/86/EEC).
DECLARATION OF CONFORMITY
Product:
CA5P – control panel CA-5
mainboard
Manufacturer: SATEL spółka z o.o.
ul. Schuberta 79
80-172 Gdańsk, POLAND
tel. (+48 58) 320-94-00
fax. (+48 58) 320-94-01
Product description: Mainboard for CA-5 control panel intended for use in intruder alarm systems.
This product meets the essential requirements and is in conformity with following EU Directives:
LVD 73/23/EEC+93/68/EEC
EMC 89/336/EWG + 91/263/EEC, 92/31EEC, 93/68/EEC
R&TTE 1999/5/EC (network connection, TBR21)
This product is compliant with the following harmonized standards:
LVD: EN 50131-1:1997; EN 50131-6:1997; EN60950:2000, EN60335-1:1994/A1:1996 Annex B
EMC: EN 55022:1998; EN 61000-3-2/-3; EN 50130-4:1995, EN 61000-4-2/-3/-4/-5/-6/-11
R&TTE: TBR 21(1998)
Gdańsk, Poland 06.05.2004
Head of Test Laboratory:
Michał Konarski
Latest EC declaration of conformity and product approval certificates can be downloaded from web site
www.satel.pl
To Next Page
