Connect the cable from your satellite receiver or portable power support to
the “Receiver” port on the Finder.
6. Switching between Satellite Name/ LNB Type/ Transponder.
2. Upgrade software & parameters via U disk.
7. Satellite Name/ LNB Type/ Transponder moves left or right.
4. Display the menu and the measured values.
Connect the cable from the LNB to the “LNB IN” port on the Finder.
5. LED Lights when 22K/13V/18V is on.
1. Receiver connecting port and power supply connection.
3. Satellite signal input.
How To Connect
2 1 4 6 5 7 3
Digital Satellite Finder
Designed for satellite dish installations.
If you want a cost effective professional satellite finder, this is the one for you!
Front Panel
Digital Satellite Finder
To Next Page
Need help?
General
