What to do if SatKing Measuring Instruments has bad picture/blocking error?
Y
yangnicoleAug 2, 2025
If you are experiencing a bad picture or blocking error with your SatKing Measuring Instruments, it could be due to several reasons:
* No signal or weak signal: Check the cable connections, LNB, and any other equipment between the LNB and the meter. Adjust the dish.
* The satellite dish is not pointing at the satellite: Adjust the dish.
* Signal is too strong: Connect a signal attenuator to the LNB input.
* Satellite dish is too small: Change to a larger dish.
* LNB noise factor too high: Change to an LNB with a lower noise factor.
* The LNB is faulty: Replace the LNB.
J
Joe MartinezAug 12, 2025
What to do if SatKing Measuring Instruments key is not working?
A
Andrea LewisAug 12, 2025
If the key on your SatKing Measuring Instruments is not working, it could be due to the following reasons:
* Out of battery: Even on adapter.
* Key blocks: Make sure there are no blocks between the front panel.
L
Leslie LeAug 21, 2025
What to do if SatKing Measuring Instruments has no display light up?
W
William BellAug 22, 2025
If the display light on your SatKing Measuring Instruments is not lighting up, it could be due to:
* The power switch is not on: Check to make sure power is on, even on adapter.
* Run out of batteries: Check to make sure power is on, even on adapter.