SATO M-8485Se - Page 108

Page 5-11
Section 5. Mechanical Adjustments
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
5.6 Timing Belt Tension Adjustment
STEP PROCEDURE
1. Push the center of each timing belt with the tension gauge and note the
tension reading when each belt is moved 1 to 2mm. Refer to Fig. 5-12 to
identify Belts A, B and C and Brackets #1, #2 and #3.
2. If the tension reading from Belt B is not within range of 500g, reposition
bracket #2. Tighten screws when belt tension is correct. Fig. 5-13
3. If the tension reading from Belt C is not within range of 500g, reposition
bracket #3. Tighten screws when belt tension is correct. Fig. 5-14
4. If the tension reading from Belt A is not within range of 500g, reposition
bracket #1. The screws are accessible from the media side of the printer.
Tighten screws when belt tension is correct. Fig. 5-15 & 5-16
Required Equipment:  500g Tension Gauge
 #2 Phillips Screwdriver
F
ig. 5-14
BELT “B”
BRACKET #2
WITH
ADJUSTMENT
SCREWS
F
ig. 5-13
BELT “C”
BELT “B”
BRACKET #3 WITH
ADJUSTMENT SCREWS