SATO M-8485Se - Print Speed

Page 6-15
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Raise the lid on the mechanical side of the printer.
3. Snap off the cover from the Dip Switch Panel. Insert a probe such as a
narrow blade screwdriver into the slots for ease in removing the cover.
Fig. 6-19
4. Remove (2) screws holding the panel to the cabinet. Fig. 6-20
5. Detach the cable connection from the panel. Fig. 6-21
6. Remove and replace the Dip Switch Panel. Reattach the cable.
7. Reconnect the power cable.
6.7 Replacing the Dip Switch Panel
6-19
Fig.
6-21
Fig.
6-20
Fig.
INSERT A NARROW PROBE
INTO COVER SLOTS FOR
EASE IN REMOVAL
REMOVE (2) SCREWS
DETACH CONNECTION