SATO M-8485Se - Section 9. Options

Page 9-2
Section 9. Options
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
9.2 Memory PC Board
The Memory PC Board provides the interface board for (1) PCMCIA memory card slot.
PCMCIA memory cards are not provided with the Memory PC Board.
MEMORY PC BOARD
STANDOFFS SHOWN AS
RECEIVED. STANDOFFS WILL
BE REMOVED AND USED TO
MOUNT MEMORY BOARD TO
THE MAIN PC BOARD
STANDOFFS SHOWN AS
RECEIVED.
TOP SCREWS MUST BE
REMOVED FOR FASTENING
TO MAIN PC BOARD
CONNECTOR IS INSTALLED
TO MATING CONNECTOR
ON MAIN PC BOARD
SLOT FOR MEMORY CARD
OPPOSITE SIDE SHOWN
Applicable Specifications PCMCIA Version 2.1 (JEIDA Version 4.1)
Size Up to 4MB SRAM
Up to 16MB Flash
Connector Pins 68
Battery Approximately two years (manufacturer dependent)
Write Protect Yes
Low Battery Detect Yes