Page 6-8
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
REMOVE (5) SCREWS TO
DETACH BACK PANEL
REMOVE LOCKING
SCREW AND SWING
CABINET OPEN
REACH INSIDE CABINET AND
DETACH CONNECTOR
Replacing the Main Circuit Board
6-9
Fig.
11. Make sure DIP Switches and jumpers are set correctly and POTS are turned to
12:00 (middle of range) before installing PCB.
12. Reinstall replacement PCB reversing steps 1 through 9.
13. Complete the Factory Reset Procedure.
STEP PROCEDURE
6-8
Figs.
To Next Page
Loading...
