SATO M-8485Se - Page 140

Page 6-27
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
Replacing the Ribbon Motion Sensor
SENSOR HARNESS @ (CN9)
CONNECTOR FOR SEN4, SEN5,
SEN6 & SEN7
CONNECTOR FROM
RIBBON MOTION SENSOR
INTO SENSOR HARNESS
MARKED “SEN4”
TWIST OPEN
CABLE TIE
REMOVE DIP
SWITCH COVER
(SHOWN REMOVED)
REMOVE
MOUNTING
SCREW
REMOVE (3) SCREWS
AND RING
(2) SCREWS ATTACHING
RIBBON MOTION SENSOR
TO BRACKET
6-34
Fig.
6-35
Fig.
Figs.
6-37
Fig.
SENSOR HARNESS
CONNECTOR TO PCB
BOARD
6-36