SATO M-8485Se - Page 142

Page 6-29
Section 6. Replacement Procedures
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
TWIST OPEN
CABLE TIE
6-39
Fig.
Replacing the Cover Open Switch
SENSOR HARNESS @ (CN9)
CONNECTOR FOR SEN4, SEN5,
SEN6 & SEN7
CONNECTOR FROM COVER
OPEN SWITCH INTO
SENSOR HARNESS
MARKED “SEN6”
Figs.
SENSOR HARNESS
CONNECTOR TO PCB
BOARD
6-40
REMOVE MOUNTING
SCREW FROM
RIBBON MOTION
SENSOR
REMOVE (2) SCREWS TO
DETACH SWITCH
FROM CABINET
PULL SEN6 THROUGH
ACCESS HOLE
6-41
Fig.
6-43
Fig.
6-42
Fig.