Page 9-9
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
Section 9. Options
Flash Memory Module Installation
INSERT THE FLASH MEMORY
MODULE INTO THE MAIN PCB
MEMORY FRAME AT
APPROXIMATELY 45
0
. NOTE THE
INDEXING NOTCH ON THE
MODULE. GENTLY PUSH DOWN TO
SNAP INTO POSITION
INDEXING NOTCHES
APPROXIMATELY
45
0
ANGLE
9-7
Figs.
9.5 Face-Out Label Sensor
Factory installed option. Top-mounted sensor for reflective "Eye-Marks" printed
on the face of the label.
To Next Page
Loading...
